Thank you for purchasing a Dart flyscreen. It has been carefully designed and manufactured to suit a specific motorcycle model and by following these instructions you should encounter no problems with fitting. 

The kit should comprise the following:

1 x Makrolon® polycarbonate screen
4 x EPDM rubber grommets
1 x left hand mounting bracket
1 x right hand mounting bracket
4 x stainless hex head machine screws
4 x washers

Tools required: you will need a 4mm and 5mm Allen key

  1. Fit the grommets to the screen - this is best achieved from the back of the screen blade. 
  2. Using a 12mm socket or spanner, slightly loosen the bolt which secures the headlight to the bottom yoke (ie the bolt under the yoke, not the headlight height adjustment bolt).
  3. Now remove the two 12mm bolts which hold the wire cable retainer to the top yoke. These are fiddly and difficult to get to - patience needed! To give a little more clearance, you can move the headlamp to the side. A small ratchet wrench helps, too.
  4. Fit the screen brackets to the yoke, then fit the wire cable retainer under these brackets, and refit the bolts. Note that the screen brackets must fit directly onto the yoke! Tighten the bolts (even more fiddly now the brackets are in the way), but not fully.
  5. With both brackets fixed, hold the screen blade in position and loosely fit the four hexagon head machine screws with their washers, ensuring that they engage in the captive nuts on the brackets. Do not tighten these yet. There will probably be a small amount of tension from the wire retainer, which should sit in the shallow recess in the brackets. If there is a lot of tension, double check that the wire part is sitting correctly on its bolts - it can move when tightening.
  6. Sit on the bike and make sure the screen is central; this is achieved by eye, lining it up with the speedometer and the centreline of the bike. You should line up the headlamp too, so that everything looks right. When this is the case, tighten up the headlamp bolt and the screen brackets. Once everything is in position, gradually tighten all the screws evenly until they are seated on the brackets. Do not overtighten these screws as damage to the brackets or threads may result.
  7. Double check that everything is sufficiently tight and if so, fitting is now complete!

MAINTENANCE: No special maintenance is required. Do not use solvents to clean - just warm soapy water. Many proprietary glass cleaners are suitable for polycarbonate - check the label before trying.

IMPORTANT NOTICE: Whilst the screen provides a good level of impact protection, it is not warranted unbreakable. It is NOT a substitute for eye protection, which should be worn at all times while riding.

Did this answer your question?